磁控溅射
Fibers and Polymers 2002, Vol.3, No.1, 24-30
Characterization of Conductive Polypyrrole Coated Wool Yarns
Akif Kaynak*, Lijing Wang, Chris Hurren, and Xungai Wang
School of Engineering and Technology, Deakin University, Geelong, Victoria 3217, Australia(Received December 28, 2001; Revised January 17, 2002; Accepted January 24, 2002)
Abstract: Wool yarns were coated with conducting polypyrrole by chemical synthesis methods. Polymerization of pyrrolewas carried out in the presence of wool yarn at various concentrations of the monomer and dopant anion. The changes intensile, moisture absorption, and electrical properties of the yarn upon coating with conductive polypyrrole are presented.Coating the wool yarns with conductive polypyrrole resulted in higher tenacity, higher breaking strain, and lower initialmodulus. The changes in tensile properties are attributed to the changes in surface morphology due to the coating andreinforcing effect of conductive polypyrrole. The thickness of the coating increased with the concentration of p-toluenesulfonic acid, which in turn caused a reduction in the moisture regain of the wool yarn. Reducing the synthesis temperatureand replacing p-toluenesulfonic acid by anthraquinone sulfonic acid resulted in a large reduction in the resistance of the yarn.Keywords: Polypyrrole, Wool, Tensile, Electrical, Moisture, Morphology
Introduction
Electrically conductive polymers have attracted a greatdeal of interest because of the variability of their electricalproperties and the sensitivity of these properties to externaleffects such as radiation, temperature, and chemicals.Conducting polymers have the unique property of wideranging modulation of their electrical conductivity. They canbe synthesized with any conductivity value, from insulatingto highly conductive, by incorporating specific concentrationsof dopant counterions during polymerization. However,fabrication of conductive polymers into useful articles hasproved difficult due to their unprocessability and poormechanical properties. These drawbacks can be overcomeby coating textile substrates with conductive polymers. Thusthe desirable electrical properties of these materials can becombined with the strength and flexibility of the textilesubstrates to produce electrically conductive fabrics that canbe used in a wide range of applications.
There have been a few publications on conductivepolypyrrole coated fabrics[1-3]. However, there are noreported data on conductive polymer coated fibers andyarns. In most of the reports, coating was achieved bychemical polymerization in the presence of the substrate,which was exposed to an oxidizing agent, monomer anddopant simultaneously or sequentially following a particularrecipe. The reaction is initiated by the oxidation of monomerinto radical cations, which combine to form dimers.Continuation of the process leads to formation of insolubleoligomers in solution, which deposit on the surface andinterstices of the textile fibers and fabrics. Due to lowoxidation potential of pyrrole, a wide range of oxidizingagents can be used to initiate polymerization. Oxidant saltssuch as ferric chloride (FeCl3) function as both the oxidant
*Corresponding author: akaynak@deakin.edu.au
24
and the dopant agent, and hence the polymer is obtained inthe conducting form. Other transition metal salts can also beused as oxidizing agents for the polymerization of pyrrole.The transition metal ion is an electron acceptor. Therefore itoxidizes the π-electron system of the pyrrole ring at theinitiation step. The intermediate steps of the polymerizationof pyrrole initiated by FeCl3 are as follows:
The pyrrole molecule is oxidized to yield a radical cationas follows[4]:
Radical cations recombine to form dications:
Deprotonation of dication to yield a dimer:
The above process continues by oxidation of the dimer toyield a radical cation of the dimer and the combination ofradical cations to form trimers, tetramers, and polymers. The



5 ? 1 导电聚吡咯的研究 李永舫 ( 中国科 学 院化 学研 究所有机 固体...展了导电聚乙炔的合成 和性 能表征研究,为国际上最早开展导电聚合物研究的几...
钼钒磷酸-聚吡咯导电杂化材... 5页 2财富值 导电高分子涂层防腐行为研... ...采用扫 描电子显微镜( SEM) 对 PPy 膜表面形貌进行表征, 观察到聚合时间和...
4期 第 高 分子通报 ·51 · 导电聚吡咯的研究李永舫 ( 中国科学院化学研究...开展了导电聚乙炔的合成和性能表征研究 , 成为国际上最早开展导电聚合物研究的...
2150 2012 年第 16 期( 43 )卷 聚吡咯 / 石墨烯复合导电材料的制备及性能表征 1 1 王春晓 , 任鹏刚 ,刘 2 蓬, 谢 1 利, 张 1 1 华, 方长青 *...
导电聚吡咯涂层的表征羊毛... 7页 8财富值 导电高分子聚苯胺在金属防... 3...金属防腐用片状导电聚吡咯粉的制备与表征冯宜绥 1,朱冬梅 2,王艳 3,杨超4 ...
聚吡咯涤纶导电织物的制备及其表征_材料科学_工程科技_专业资料 暂无评价
聚吡咯的制备、表征及气敏性研究_理学_高等教育_教育专区。导电聚吡咯的研究第34卷/第6期/ 2010年11月 河北师范大学学报/自然科学版/JOU只NALOFHEBEINO只MALUNIVE...
第4期 高 分 子 通 报 51 导电聚吡咯的研究李永舫 ( 中国科学院化学研究...开展了导电聚乙炔的合成和性能表征研究, 成为国际上最早开展导电聚合物研究的几...
聚吡咯/木单板导电复合材料的制备与表征_专业资料。以FeCl3为氧化剂和掺杂剂,采用化学氧化原位吸附聚合法制备了聚吡咯/木单板复合材料。探讨了制备条件对表面电阻率...
过渡金属—取代Keggin结构钼磷酸盐掺杂的聚吡咯的制备、表征与导电性研究_IT/计算机_专业资料。维普资讯 http://www.cqvip.com 第6 期 200 2年 6月 无 机 化...
热门文档