经典LEAN型阳光房PVC安装手册

Tools required8, 10, 13mm

Socket SpannerDeadblow Hammer or White

Rubber MalletNo. 2 Pozi-drive BitHack Saw Drill/ScrewdriverLong nose pliarsGasket Shears/Snips

4.5mm Drill Bit

10mm Drill BitSealant Gun2 x 5mm Allen Keys (Vic xing kit)17mm Open Ended Spanner

- Tie Bars Spirit Level Tape MeasureAngle nderPlumb bob

Eaves to frame xings and host wall xings not supplied.

General pointsCare should be taken when handling components that are seen

by the homeowner, as surfaces may be scratched if not handled

with care. Choose a suitable area for unpacking the components

and always check them before tting. Any claims for missing or

damaged parts are only accepted in line with our standard terms

and conditions of sale.

The majority of aluminium and PVCu components contain identi cation codes, usually by inkjetting or labelling – should you need to re-order a part this should help. Sealing

Health & safetySite safety is particularly important. The installation company

shall be responsible for the safety of all of the tting team, the

customer and members of the public.

The Surveyor should have carried out a risk assessment to

reduce risk on site and this should have been discussed with you

prior to starting.

Please use safe working platforms and ladders that comply with

BS EN 131. Always use equipment in line with manufacturers

recommendations .Personal Protective Equipment –such as

goggles, mask and ear defenders – should be used when , for

example, grinding out for the ashing.

Careful consideration should be given to the safe disposal of all

packaging – Ultraframe packaging is predominantly made from

recycled materials and can be readily recycled.It is important to use the correct sealant when sealing the roof.1. For Roofs glazed with Polycarbonate (or standard sealed units) a low modulus neutral cure brand of silicone must be used2. For roofs glazed with Pilkington Activ or other true ‘self cleaning’ glass, then MS Polymer sealant such as Rotabond 2000 must be used.Sealed UnitsAll protective handling tape must be removed prior to installation. For the correct selection of sealant please see aboveThe SuperstructureCheck the Dwarf wall or Plinth for being level all round. Ensure that all frames/bifold doors which abut the host wall are vertically plumb, which will then allow perfect alignment with the Ultraframe eaves beam. Before starting to install the roof, please check the condition of the host wall and whether it’s plumb – depending upon what you nd, these conditions can seriously affect the nal

integrity of the roof.

ProductThe roof kit is supplied with a location plan, a quality control

check list for the box in which this guide arrives and ,of course,

this installation guide. The location plan is used to match

individual components to their respective position on the roof.

Our numbering convention always starts at the top left, against

the house wall as you look from outside the conservatory back at

the host wall.Technical SupportTel 0843 208 6953Fax 0843 208 6952Email

经典LEAN型阳光房PVC安装手册