文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 机械/仪表 > Coupled Surface-Subsurface Model for Simulating Drainage from Permeable Friction Course Highways
侵权投诉

Coupled Surface-Subsurface Model for Simulating Drainage from Permeable Friction Course Highways

Coupled Surface-Subsurface Model for Simulating Drainage from Permeable Friction Course Highways

Bradley J. Eck, M.ASCE1; Michael E. Barrett, M.ASCE2; and Randall J. Charbeneau, M.ASCE3

Abstract: Permeable friction course (PFC) is a porous asphalt pavement placed on top of a regular impermeable roadway. Under small rainfall intensities, drainage is contained within the PFC layer; but under higher rainfall intensities, drainage occurs both within and on top of

the porous pavement. A computer model—the permeable friction course drainage code (Perfcode)—is developed to study this two- dimensional unsteady drainage process. Given a hyetograph, geometric information regarding the roadway layout, and hydraulic properties of the PFC media, the model predicts the variation of water depth within and on top of the PFC layer through time. The porous layer is treated as an unconfined aquifer using Darcy’s law and the Dupuit-Forchheimer assumptions. Surface flow is modeled using the diffusion wave

approximation to the Saint-Venant equations. A mass balance approach is used to couple surface and subsurface phases. Straight and curved roadway geometries are accommodated via a curvilinear grid. The model is validated using steady-state solutions that were obtained inde- pendently. Perfcode was applied to a field monitoring site near Austin, Texas, and hydrographs predicted by the model were consistent with

field measurements. For a sample storm studied in detail, PFC reduced the duration of sheet flow conditions by 80%. In a second sample storm, PFC prevented sheet flow conditions completely. The model may be used to improve the drainage design of PFC roadways. DOI: 10 .1061/(ASCE)HY.1943-7900.0000474. © 2012 American Society of Civil Engineers.

CE Database subject headings: Hydraulic models; Porous media; Pavements; Sheet flow; Drainage; Simulation. Author keywords: Hydraulic models; Porous pavement; Sheet flow; Dupuit-Forchheimer.

Downloaded from ascelibrary.org by Hohai University Library on 12/16/12. Copyright ASCE. For personal use only; all rights reserved.

Introduction

of an arbitrarily thick porous layer. Additionally, PFC has been shown to clog over time, resulting in lower subsurface drainage

Conventional highways are paved with concrete or asphalt and capacity (NCHRP 2009). Therefore, some storms will exceed drainage occurs across the roadway according to the longitudinal the installed capacity, forcing drainage to occur both on the pave- slope and cross-slope. Drainage may be improved by overlaying ment surface and within the porous matrix. This paper describes a

model for this coupled unsteady drainage process. the roadway with porous asphalt so that drainage occurs within

There are three published predictions of water depth in PFC for the pavement rather than across it. The overlay of porous

asphalt—called permeable friction course (PFC) or open graded straight roadway sections under constant rainfall. Ranieri (2002)

gives a numerical solution to the governing equation and a design friction course—is commonly placed in a 50-mm or thinner layer

chart. Tan et al. (2004) use a commercial finite element program to on top of conventional, impermeable pavement. During rain events,

model flow through PFC. Both Ranieri (2002) and Tan et al. (2004) water seeps into the porous layer and flows to the side of the road

by gravity. By removing water from the road surface, PFC im- provide charts to find the required thickness of PFC from slope

information and rainfall intensity. Charbeneau and Barrett (2008) proves safety by reducing splashing and hydroplaning (Berbee et al.

provide an analytical solution for the saturated thickness along the 1999). In addition to safety benefits, PFC has also been shown to

flow path. reduce pollutants commonly observed in highway runoff (Barrett,

These three papers consider the same roadway geometry: a

2008).

straight road with constant longitudinal slope and cross-slope.

Although usually placed in a 50-mm layer, the PFC thickness

The drainage slope is the Pythagorean sum of the longitudinal slope

may be selected so that all of the rainfall for a design event drains

and the cross-slope. In these papers, the drainage slope is a con-

within the pavement. Structural and cost concerns prevent the use

stant, making the problem one-dimensional (1D). Under constant rainfall intensity, the system reaches a steady state. It is this 1D 1

Postdoctoral Fellow, Center for Research in Water Resources, The

steady-state solution that these writers present. A comparison of Univ. of Texas at Austin, Austin, TX 78712 (corresponding author). E-mail:

their predictions reveals that Charbeneau and Barrett (2008) and bradleyjeck@gmail.com

2 Ranieri (2002) have essentially identical results. Tan et al. (2004) Research Associate Professor, Center for Research in Water Resources,

The Univ. of Texas at Austin, Austin, TX 78712. E-mail: mbarrett@mail obtain a different result, predicting a thinner porous layer than the .utexas.edu other workers. The reasons for this discrepancy are difficult to un- 3

Professor of Civil Engineering, Center for Research in Water cover because Tan et al. (2004) used a commercial finite element Resources, The Univ. of Texas at Austin, Austin, TX 78712. E-mail: program for analysis. charbeneau@mail.utexas.edu

Very little has been mentioned in the literature regarding

Note. This manuscript was submitted on July 12, 2010; approved on

the coupling between surface and subsurface flow in PFCs.

June 13, 2011; published online on June 15, 2011. Discussion period open

Charbeneau and Barrett (2008) address the issue briefly and until June 1, 2012; separate discussions must be submitted for individual

provide an estimate of sheet flow thickness on the basis of the papers. This paper is part of the Journal of Hydraulic Engineering,

Darcy-Weisbach equation. Eck et al. (2011) refined the coupling Vol. 138, No. 1, January 1, 2012. ©ASCE, ISSN 0733-9429/2012/1-

between PFC and sheet flow by using a different boundary 13–22/$25.00.

JOURNAL OF HYDRAULIC ENGINEERING © ASCE / JANUARY 2012 / 13

第1页

TOP相关主题

你可能喜欢

热门文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email