551.574.14: 551.574.7
T h e density and structure of ice formed by accretion By W. C. MACKLIN Imperial College, London* (Manucript received 19 May 1Y61)
SUMMARY Studies have been made of ice formed by accretion over a wide range of controlled conditions to ascertain the influence of the wind speed, ambient temperature, droplet diameter and liquid-water concentration in the supercooled cloud, and the size of the accreting object. The density of the deposits ranged from 0.1 to 0.9 g~ m - the density increasing with increases in the first four of the above parameters but decreasing with~, increasing object size. It was found that the density could be expressed as a function of - ru,/T,, T being the median volume radius of the droplets comprising the cloud, uo the speed with which the droplets struck the object and T,the mean temperature of the accreting surface (in"C). The quantity rzi0 is interpreted as being a measure of the force with which the droplets were packed together and Tsthe temperature which governed their freezing rate. A microscopic examination of the deposits showed that at low values of - ru,/T, (corresponding to low densities) the droplets tended to freeze together as spheres while at higher values they were distorted and spread considerably before freezing.
1. INTRODUCTION
Whenever supercooled droplets strike a cold object they freeze and form an ice deposit. Familiar examples of this phenomenon are rime formation during winter fogs and the icing of aircraft and growth of hailstones in supercooled clouds. The ice formed in this way may assume a wide variety of forms and structures and have a wide range of densities (about 0.1 to 0.9 g~ m -~ )The dependence of these characteristics on the possible para. meters involved (airspeed, ambient temperature, droplet diameter, liquid-water concentration in the supercooled cloud, and size and shape of the accreting object) is not yet clearly understood. The properties of rime ice are important in a number of connexions. In particular, in theories of hail formation the rate of growth and ultimate stone size are dependent on the assumed density with which accreted water is deposited. A concerted effort on this problem has been made at the Mount Washington Observatory, U.S.A. (see, e.g., the Harvard-Mount Washington Icing Research Report, 1946-47). Density measurements were made after exposing a number of coaxial cylinders, rotated to give a uniform deposit, within the orographic cloud frequently formed at the summit and the results correlated with the various meteorological parameters listed above. Langmuir (1944) derived a set of empirical formulae, based on seventeen series of such measurements using a set of six cylinders ranging in size from 0.2 to 7.6 cm (of which five series were later rejected as not fitting the formulae). These gave the rime density as a function of the ambient temperature, droplet radius and impact speed at which the droplets struck the cylinders, the densit
y increasing with increases in each of these quantities. No dependence was found on the rate of accretion. Langmuir interpreted these factors as affecting the rate of freezing and impact energy of the accreted droplets and therefore as determining the penetration of freezing droplets into the existing rime structure with a consequent effect on the density. In order to verify his formulae, Langmuir computed the densities of the rime deposits, the measured densities of which had been used in the analysis, and in plotting the computed against the measured values found deviations from the expected straight line of about 0-15 g~ m -~ . is a considerable error at low densities and, as Ludlam This (1958) suggests, the formulae may be applicable only to conditions peculiar to low-level orographic clouds, since the cloud parameters are undoubtedly interrelated (as Langmuir himself showed). Now at Departmmt of Physics, Nedlands, University of Western Australia. 30

更多>>We consider the effects of "photon bubble" shock trains on the vertical structure of radiation pressure-dominated accretion disks. These density ...
We find that OBC plays an important role in determining the topological structure and the profiles of the surface density and tempera隐藏>> Accretion ?ows...
The Structure and Emission of the Accretion Shock in T Tauri Stars II the Ultraviolet Conti We compare accretion shock models with optical and ultraviolet...
1992) for treating the radiative transfer in AGN accretion discs to include the vertical density structure as well as temperature structure within the disc....
Changes in the structure of the accretion disc of V2051 Ophiuchi through the outburst cycle We present the results of the analysis of light curves of...
erent consequences for the structure of the ionized accretion ?ow and HII ...The model is described by a few parameters: the gas density in the ?ow...
Changes in the structure of the accretion disc of HS1804+67 through the outburst cycle We report on the analysis of high-speed photometry of the ...
Thermal-viscous instabilities in the accretion ...structure of the X-ray light curve, all ...A new hole is formed and a new cycle starts....
On the Vertical Structure of Radiation-Dominated Accretion Disks The vertical...At the midplane, the density is large, and the magnetic pressure and ...
Disk Properties and Density Structure of the Star-Forming Dense Core B335...accretion, accretion disks Based on observations carried out with the IRAM ...
热门文档