SPE 106304 Fracturing Fluid for Low-Permeability Gas Reservoirs Emulsion of Carbon Dioxide
SPE 106304
Fracturing Fluid for Low-Permeability Gas Reservoirs: Emulsion of Carbon Dioxide With Aqueous Methanol Base Fluid: Chemistry and Applications
D.V.S. Gupta, SPE, BJ Services Co., and B.T. Hlidek, SPE, E.S.W. Hill, SPE, and H.S. Dinsa, BJ Services Co. Canada
Copyright 2007, Society of Petroleum Engineers
This paper was prepared for presentation at the 2007 SPE Hydraulic Fracturing Technology Conference held in College Station, Texas, U.S.A., 29–31 January 2007.
This paper was selected for presentation by an SPE Program Committee following review of information contained in an abstract submitted by the author(s). Contents of the paper, as presented, have not been reviewed by the Society of Petroleum Engineers and are subject to correction by the author(s). The material, as presented, does not necessarily reflect any position of the Society of Petroleum Engineers, its officers, or members. Papers presented at SPE meetings are subject to publication review by Editorial Committees of the Society of Petroleum Engineers. Electronic reproduction, distribution, or storage of any part of this paper for commercial purposes without the written consent of the Society of Petroleum Engineers is prohibited. Permission to reproduce in print is restricted to an abstract of not more than 300 words; illustrations may not be copied. The abstract must contain conspicuous acknowledgment of where and by whom the paper was presented. Write Librarian, SPE, P.O. Box 833836, Richardson, TX 75083-3836, U.S.A., fax 01-972-952-9435.
Abstract
High-quality emulsion of carbon dioxide (CO2) in aqueous alcohol-based gel (CO2 emulsion) was introduced into the Western Canadian Sedimentary Basin (WCSB) as a fracturing fluid in 1981. Since that time, the use of the fluid has been very successful, particularly in low-pressure, tight gas applications. The fluid has all the advantages of conventional high-quality CO2 foams/emulsions, with the added advantage of minimizing the amount of water introduced into the well. The present paper will discuss a fluid that is an emulsion of liquid carbon dioxide in a base fluid of aqueous methanol. The discussion will include chemistry, rheological evaluations, and successful field utilization of these fluids in the Western Canadian Sedimentary Basin over the last decade.
Introduction
With ever-increasing need for resources world wide, the industry continues its trend to exploit gas reservoirs with ever-lower permeabilities. Very low-permeability reservoirs are typically in a state of capillary under-saturation, where the initial water and sometimes hydrocarbon saturation is less than would be expected from conventional capillary mechanics for the pore system under consideration (1). These formations are also called desiccated or dehydrated formations and have been known to exist all over the world.
Introducing an additional immiscible phase, or increasing the existing phase saturation within porous media, can substantially damage permeability and relative permeability to hydrocarbons. This phenomenon is commonly described as aqueous or hydrocarbon phase trapping, depending on the situation under consideration.
The most common technique for preventing these problems involves eliminating the use of water-based fluids. Even fluids with very low fluid loss (to minimize invasion depth into the formation) may be susceptible to countercurrent
spontaneous imbibition effects in desiccated reservoirs. The most successful means of mitigating these effects has been to use interfacial tension-reducing agents (e.g., mutual solvents or surfactants), or miscible gases such as carbon dioxide or LPG.
When translated to fracturing fluids, this involves developming fluids that utilize the above mentioned agents in a non-damaging way. The use of CO2 as an energizing medium for fracturing fluids is an old concept (2). The concept of high-quality foam as fracturing fluid has also been previously reviewed (3). Bennion has discussed the use of methanol and CO2 to minimize and remove damage in low-permeability gas reservoir (4). Thus, a natural extension of these concepts is to combine all the benefits of these fluids, i.e., develop an emulsion fluid that uses high-quality CO2 (80 Mitchell quality or higher) with 40% methanol in place of water in the external gel phase.
Properties of Methanol and use in Fracturing Fluid Formulations
Methanol has some attractive properties that make its use in fracturing fluid formulations attractive (5). Using 40-% methanol in water lowers the surface tension of water from 72 dynes/cm to around 40 dynes/cm, the freezing point from 0 ooC to –40 C, the specific gravity from 1 to 0.95. At the same time, the vapor pressure of water is increased from 17.5 to 46.5 mm of Hg at 20 oC and from 150 to 300 mm of Hg at 60 oC, which helps in recovering the fluid. Likewise, the fluid viscosity goes up by 60% when methanol is added to water at a concentration of 40%.
A 40% methanol-containing aqueous system can be gelled with several polymers including conventional hydroxypropyl guar (HPG), carboxymethyl hydroxypropyl guar (CMHPG) and polymers used to viscosify pure methanol (5,6). Figure 1 displays the viscosities of the various polymers in 40% methanol. These gels are compatible with both liquid and gaseous CO2 without precipitation.
The rheology for the aqueous alcohol/CO2 emulsion is measured with testing apparatus described previously (7) (Figure 2). This is a modified PC-10 cement consistometer converted into a flow-through recirculating rheometer. The base gel with the aqueous alcohol fracturing fluid is injected into the apparatus at valve 5. A measured volume of liquid CO2 is introduced into the apparatus at valve 2 at room temperature and a pressure of 5.5 MPa. The system is then

pressurized to approximately 7 to 8 MPa with the air-driven
天 Application of Fracturing Technique for Low Permeability Gas Reservoirs ZOU...fracturing fluid system, in the paper a series of hydraulic fracturing ...
ective in both low and high permeability ...fracturing unconventional reservoirs include OptiKleen-... SPE 106304 Fracturing ... 4页 1下载券 Novel ...
techbits Refracturing in Low-Permeability Reservoirs ...“Fracturing Fluid Viscosity Impact on Codell ... paper SPE 25464 presented at the 1993 SPE ...
Shale Gas Reservoirs_ Dec 2014 Beijing _Dr ...Leads to permeability change estimate Low Sorption ...Hydraulic fracturing o Practically a biaxial stress...
Not all shale gas reservoirs are the same, nor...and low horizontal stress anisotropy SPE 2007 6 ... matrix permeability, fracturing Integration: The ...
Shale Gas Reservoirs_其它语言学习_外语学习_教育...permeability with hydraulic fracturing - which is ...On the other hand, low clay content, moderate-...
using liquid C02 as the sole fracturing fluid for the placement of ...7922 presented at the 1979 SPE Symposium on Low Permeability Gas Reservoirs,...
LPG Fracturing Technology Tim O’Rourke 2nd China...permeability 11 2 9 1b Fluid 1 (0.00033 mD,...Gas from our reservoirs – Sustainability Frac ...
proppant?transport Useful?in?low?pressure?gas?...emulsion ? Micellar?fluid?systems?(ClearFrac) –...from?frac?face ??2009 Ppore Typical?Fracturing?...
Fracturing the pay zone? ? Simple fact – 1 ...gas that is locked in low permeability reservoirs...SPE 115766 Fracs Self-Limited by Frac Fluid ...
热门文档