TLC2543
TLC2543C, TLC2543I, TLC2543M 12-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROL AND 11 ANALOG INPUTS SLAS079F– DECEMBER 1993– REVISED NOVEMBER 2001
absolute maximum ratings over operating free-air temperature range (unless otherwise noted) Supply voltage range, VCC (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 0.5 V to 6.5 V Input voltage range, VI (any input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 0.3 V to VCC+ 0.3 V Output voltage range, VO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 0.3 V to VCC+ 0.3 V Positive reference voltage, Vref+ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VCC+ 0.1 V Negative reference voltage, Vref– . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 0.1 V Peak input current, II (any input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .± 20 mA Peak total input current, II (all inputs) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .± 30 mA Operating free-air temperature range, TA: TLC2543C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C TLC2543I . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 40°C to 85°C TLC2543M . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 55°C to 125°C Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .– 65°C to 150°C Lead temperature 1,6 mm (1/16 inch) from the case for 10 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C Stresses beyond those listed under“absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under“recommended operating conditions” is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. NOTE 1: All voltage values are with respect to the GND terminal with REF– and GND wired together (unless otherwise noted).
recommended operating conditions MIN Supply voltage, VCC Positive reference voltage, Vref+ (see Note 2) Negative reference voltage, Vref– (see Note 2) Differential reference voltage, Vref+– Vref– (see Note 2) Analog input voltage (see Note 2) High-level control input voltage, VIH Low-level control input voltage, VIL Clock frequency at I/O CLOCK Setup time, address bits at DATA INPUT before I/O CLOCK↑, tsu(A) (see Figure 4) Hold time, address bits after I/O CLOCK↑, th(A) (see Figure 4) Hold time, CS low after last I/O CLOCK↓, th(CS) (see Figure 5) Setup time, CS low before clocking in first address bit, tsu(CS) (see Note 3 and Figure 5) Pulse duration, I/O CLOCK high, twH(I/O) Pulse duration, I/O CLOCK low, twL(I/O) Transition time, I/O CLOCK high to low, tt(I/O) (see Note 4 and Figure 6) Transition time, DATA INPUT and CS, tt(CS) TLC2543C Operating free-air temperature, TA TLC2543I TLC2543M 0– 40– 55 VCC= 4.5 V to 5.5 V VCC= 4.5 V to 5.5 V 2.5 0 2 0.8 0 100 0 0 1.425 120 120 1 10 70 85 125°C 4.1 4.5 NOM 5 VCC 0 VCC VCC+ 0.1 VCC MAX 5.5 UNIT V V V V V V V MHz ns ns nsµs ns nsµsµs
NOTES: 2. Analog input voltages greater than that applied to REF+ convert as all ones (111111111111), while input voltages less than that applied to REF– convert as all zeros (000000000000). 3. To minimize errors caused by noise at the CS input, the internal circuitry waits for a setup time after CS↓ before responding to control input signals. No attempt should be made to clock in an address until the minimum CS setup time has elapsed. 4. This is the time required for the clock input signal to fall from VIHmin to VILmax or to rise from VILmax to VIHmin. In the vicinity of normal room temperature, the devices function with input clock transition time as slow as 1µs for remote data acquisition applications where the sensor and the A/D converter are placed several feet away from the controlling microprocessor.
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265

TLC2543引脚、功能及时序中文资料_IT/计算机_专业资料。TLC2543 引脚、功能及时序中文资料模块采用 TI 公司的 TLC2543 12 位串行 A/D 转换器,使用开关电容逐次...
TLC2543-EP中文资料 暂无评价 25页 免费 TLC2543-EVM中文资料 暂无评价 52页 免费 TLC2543资料c语言 8页 免费喜欢此文档的还喜欢...
74HC138中文资料 5页 免费 TLC2543简介 9页 2下载券 TL2543_C51驱动程序 暂无评价 4页 免费tlc2543中文资料...
TLC2543 中文资料_工学_高等教育_教育专区。TLC2543 中文资料 TLC2543 是 TI... TLC2543(中文) 13页 1下载券 tlc2543中文资料 36页 1下载券...
TLC2543中文数据手册_信息与通信_工程科技_专业资料。TLC2543ADC转换芯片,英文数据手册翻译TLC2543 使用手册 一、简要说明: TLC2543 是一款 8 位、 位、 位为...
TLC2543IDBRQ1中文资料_电子/电路_工程科技_专业资料 暂无评价0人阅读0次下载举报文档 TLC2543IDBRQ1中文资料_电子/电路_工程科技_专业资料。元器件交易网www...
TLC2543中文资料_信息与通信_工程科技_专业资料 暂无评价 0人阅读 0次下载 举报文档 TLC2543中文资料_信息与通信_工程科技_专业资料。TLC2543中文资料串行...
TLC2543中文资料_信息与通信_工程科技_专业资料。TLC2543中文资料串行AD 转换器 TLC2543 中文资料 TLC2543 是 TI 公司的 12 位串行模数转换器,使用开关电容逐次...
(65536-50000)/256; TL0 = 176; // (65536-50000)%256; TMOD = 0x20 ... tlc2543中文资料 36页 1下载券 基于tlc2543的电压表c语... 3页 2下载券...
TLC2543(中文) 13页 1下载券 TLC2543程序 4页 1下载券 TLC2543应用 7页 ... TLC2543驱动程序 2页 1下载券 tlc2543资料 27页 免费喜欢此文档的还喜欢...
热门文档